This Kenwood TL-922A HF Linear Amplifier, covers 15-160 Meters and is in Excellent cosmetic and working Condition. You will be hard pressed to find a nicer, cleaner (inside and out) TL-922A Amplifier. I tested this amplifier on the air and it puts out about 1200 Watts on 14 MHz and worked very well on all bands I did notice that the Plate control for 40 and 10 meters is not exactly in the range on the plate control at the point of resonance . This may vary a bit or the control may be off a bit and needs to be adjusted but the amplifier work fine other than the Plate control reading off a bit on those two bands. It is set up for 115 volts AC right now as I put it on 115 volts for testing it so I could bring it up with the 115 volt Variac. It is very easy to switch to 230 VAC right on the rear panel. The tubes appear to be the original Eimac tubes and appear to be full or very near full output. I prefer a pick up on this amplifier but I can ship it if required, I am one of the best in the business packing and shipping vintage gear, but there is always risk shipping heavy items. Shipping will be at the risk of the buyer for anything not covered by insurance. If picked up here in NE Wisconsin, the shipping charge will be refunded. I actually have the original box however it does not provide adequate protection for modern shipping. It is a single large box that will not afford proper protection that a double box system will provide. If you do want the original box, I can ship it separate for the actual cost of shipping it. The shipping cost will cover the (2) Eimac tubes shipped in a separate box from the Amplifier. The shipping quote is an estimate and may be less depending on your location in relation to my point of shipping. If the amount is less I will refund the difference to you.