This RL Drake Delrin High Quality Finger Divot for the C-Line Spinner Knob, is made to specifications of the original Drake C-Line spinner knob.
These finger divots are a perfect replacement for missing or old damaged spinner finger divots.
To install, you slip the divot through the hole, cut to length so about 1/8 inch of the shaft is exposed on the back side, and touch a hot solder iron on the end lightly to slightly mushroom out the end so it stays in place.
The are special made with a slight ridge on the circumference, to allow the divot to spin without binding.
They were expensive to have made for a production run of original Drake C-Line spinner knobs, however the parts and mold to make the complete assemblies are gone for good so these are part of the over run.
They will also work for other knobs to convert to a spinner knob if desired.
I am selling them at my cost.
Shipping in the USA is Free, International shipping is $6.00 to be added onto the total after check out.
NOTE: The complete knob in the photo gallery is not included and is shown for reference only!